news

How to quote for the installation of spiral chutes? 1. Overview: Gravity separation is widely used in the beneficiation of metal and non-ferrous metals due to its low pollution and low cost. Spiral chute is one of the gravity beneficiation machines, characterized by a cubic parabolic cross-section, suitable for processing finer particle sizes of -0.2 millimeters. During the sorting process, there is no need to add water for flushing, and the end of the chute is divided into sections to select fine, medium, and tailings. 2、 Technical principle: The fiberglass spiral chute separator can be freely placed on a cross (or tripod) on a support table. Equal slurry is slowly fed onto the surface of the rotating groove through the feeding chute installed at the head of the spiral groove, and sorting is carried out. The tail is equipped with a valve type product selection slot, which divides the selected equipment into three (or four) categories according to grade along the radial direction. Change the cutting width of each product by adjusting the orientation of the valve block. The equipment gathering bucket is a concentric circular tube that allows the obtained multi-directional mineral flow to be densely drawn out. The cross-section of the spiral chute and the slope change of the curve are particularly suitable for the separation of fine particle materials. How to quote for the installation of spiral chutes at 3. Advantages or characteristics: 1. High efficiency, high recycling rate, and correct mineral sorting; 2. No power required; 3. Lightweight, rust resistant, durable, wear resistant, and corrosion-resistant; 4. Low cost and long service life; 5. It is applicable to the fluctuation of feed volume, density, Granularity and grade; The friction force on the surface of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. How to quote for the installation of a spiral chute? 4. The structural composition of a fiberglass chute consists of six parts: a feeding distributor, a feeding chute, a rotating chute, an equipment selection chute, a product gathering hopper, or a groove bracket (including a cross or triangular frame). The spiral groove formed by connecting spiral pieces is a key accessory. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue), connected together by screws, and the rotating groove has a pre designed durable wear-resistant layer on the selected surface. It also has the advantages of light weight, durability, and durability in using consumer goods. Above the spiral groove is a multi tube feeding homogenizer that screens ore evenly, making it easy and convenient to operate. The sorting machine is not limited to being placed on the cross (or tripod) of the support table. The uniform mortar is slowly fed onto the spiral groove surface by installing the feeding groove at the head end of the rotating groove for sorting. The tail of the rotating groove is equipped with a valve type new equipment to cut the groove and classify the selected new products into three categories (or four categories) radially according to grade. Change the width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that allows the selected multi head ore flows to converge and lead out separately. The cross section and slope of the curve of the spiral concentrator are particularly suitable for the selection of fine-grained ore. How to quote for the installation of spiral chute V. Scope of use Spiral concentrator is suitable for separating fine grained iron ore, Ilmenite, Chromite, pyrite, cassiterite, tantalum niobium ore, placer gold, coal, monazite, Rutile ore, zircon sand, rare earth ore and other metal and non-metallic mineral materials with sufficient density ratio difference. How to quote for the installation of the spiral chute