news

Spiral Chute Technical Parameters: Spiral Chute Technical Parameters 1. Introduction: Gravity beneficiation is widely used in metal and non-metallic ore beneficiation due to its small environmental pollution and low cost. The fiberglass chute is one of the gravity separation equipment, with a structural feature of a cubic parabolic cross-section, suitable for handling finer particle sizes of -0.2mm. During the sorting step, there is no need to add flushing water, and the fine, medium, and tailings are segmented at the bottom of the chute. 2、 The principle of operation is that the spiral concentrator does not limit the placement of the mineral screening device on the cross (or tripod) of the support table. The average mineral mortar is slowly fed onto the spiral groove surface through a feeding groove installed on the rotating groove head, and the selection is carried out. The bottom is equipped with a valve block type equipment cutting groove, allowing the sorted products to be divided into three (or four) types according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that aggregates and leads out the obtained multi head ore flow. The transverse section of the fiberglass chute and the change in slope of the curve are particularly suitable for the selection of small particle materials. Spiral chute technical parameters III. Advantages or characteristics: 1. High efficiency, high recycling rate, and correct mineral sorting; 2. No power required; 3. Lightweight, rust resistant, durable, wear resistant, and corrosion-resistant; 4. Low cost and long service life; 5. It is applicable to the fluctuation of feed volume, density, Granularity and grade; The friction force on the surface of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. Technical parameter 4 of the spiral chute. The structural composition of the fiberglass chute is composed of 6 parts, including a feeding homogenizer, a feeding groove, a rotating groove, a product cutting groove, an equipment gathering hopper or a groove bracket (including a cross or triangular frame), etc. The spiral groove connected by the spiral plate is the main component. The rotating plate is made of fiberglass (fiber reinforced coal gangue), which is connected together through screws. The selected surface of the rotating groove has a predetermined wear-resistant layer. It also has the advantages of lightweight, sturdy, and durable consumer goods. Above the spiral groove, there is a multi tube feeding homogenizer for ore dressing and averaging, with simple control. The mineral screening device is freely placed on a cross (or tripod) on a support table. The evenly distributed mortar is slowly fed to the rotating groove surface by installing it on the feeding groove at the end of the spiral groove head, and sorting is carried out. The tail end of the spiral groove is installed in a valve block type new product acquisition groove, and the selected new products are divided into three categories (or four categories) of new equipment along the radial direction according to grade. Change the selection width of each new product by adjusting the orientation of the valve block. The new product gathering bucket is a concentric circular tube that allows the intercepted variable mineral flows to be gathered and exported separately. The cross section and slope of the curve of the spiral concentrator are particularly suitable for the separation of fine ore materials. 5、 The spiral chute is suitable for separating fine grained iron ore, ilmenite ore, chromite ore, pyrite ore, sand tin, tantalum niobium ore, placer gold ore, coal mine, monazite ore, Rutile ore, zircon ore, rare earth ore, and has enough Density contrast to obtain other metal and non-metallic mineral materials. Technical parameters of spiral chute