Coal washing spiral chute quotation 1. Introduction Gravity beneficiation is widely used in the beneficiation of metallic and non-metallic ores due to its low environmental pollution and low cost. The fiberglass spiral chute is a type of gravity separation machine, characterized by a cubic parabolic shape on the cross-section. It is suitable for processing finer particles up to -0.2mm in size. In the sorting process, there is no need to add water for flushing, and the end of the chute is divided into sections to obtain fine, medium, and tailings. 2、 Technical principle: The fiberglass spiral chute mineral separator is not limited to stacking on the cross (or tripod) of the support table. The average mineral mortar is slowly fed onto the spiral groove surface through a feeding groove installed at the end of the rotating groove head for sorting. The tail is equipped with a valve type product selection slot, which divides the selection equipment into three types (or four types) according to grade along the radial direction. Change the cutting width of each product by adjusting the orientation of the valve block. The equipment gathering bucket is a concentric circular tube that allows the obtained multi head ore flow to gather and lead out. The cross section of the spiral chute is particularly suitable for the selection of fine ore particles due to changes in the slope of the curve. Coal washing spiral chute quotation: III. Features: 1. Stable sorting steps, easy control. 2. Wide range of ore concentration allowed. 3. High enrichment ratio, high recovery rate. 4. Small area occupied and low water consumption. 5. Simple structure, no power required. 6. Large production capacity. 7. Simplified installation and simple operation. 8. Low investment and quick results. Coal washing spiral chute quotation. 4 The structure of the fiberglass spiral chute is composed of a feeding device, a cross (tripod), a feeding chute, a spiral groove, a receiving groove, a gathering bucket, and a groove pillar. Coal washing spiral chute quotation 5. The use of a field spiral concentrator is suitable for processing 0.6-0.03MM and vein ore and minerals, but high mud content is unfavorable for sorting. Currently, it has been widely used for processing iron ore, tungsten, tin ore sand, tantalum niobium, bay and riverside ore and placer gold. Quotation for Coal Washing Spiral Chute