news

Spiral Chute Slurry Distribution 1. Product Introduction: A gravity separation machine used for separating light and heavy minerals in mineral mortar under inertial centrifugal force during spiral motion. 2、 Production principle: The spiral concentrator is freely placed on the cross (or tripod) of the support table. The evenly proportioned mortar is slowly fed onto the surface of the spiral groove through the feeding chute installed at the head of the rotating groove, and sorting is carried out. The tail end is equipped with a valve block type equipment cutting groove, which divides the sorted products into three (or four) categories according to grade along the radial direction. Change the acquisition width of each product by adjusting the position of the valve block. The equipment gathering bucket is a concentric circular tube that allows the selected variable ore flows to converge and export differently. The cross section and slope of the curve of the fiberglass chute are very suitable for the separation of small particle materials. Spiral chute slurry distribution 3. Features 1. Stable selection process, easy operation 2. Wide range of allowable changes in feed density 3. High enrichment ratio, high recycling rate, 4. Small land area and low water consumption 5. Simple structure without power 6. Large processing output 7. Easy installation and operation 8. Small investment and quick results Spiral chute slurry distribution 4 The structural composition of the fiberglass chute consists of six parts: a feeding distributor, a feeding trough, a rotating trough, an equipment cutting trough, a product gathering hopper, and a trough support (including a cross or triangular frame). The spiral groove formed by the connection of spiral plates is a key component. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue) and is bolted together. The selected surface of the rotating groove has a pre designed durable wear-resistant layer. It has the advantages of being lightweight, sturdy, durable, and not easily damaged consumer goods. The spiral groove is equipped with a multi tube feeding homogenizer to divide ore evenly, making it easy to operate. The concentrator is not limited to being placed on the cross (or tripod) of the support table. The evenly divided mineral mortar is slowly fed onto the spiral groove surface through the feeding chute at the head of the rotating groove for sorting. The tail of the rotating groove is installed in a valve type new product selection groove, and the selected new products are divided into three types (or four types) of new equipment along the radial direction according to grade. Change the width of each new product by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that allows the intercepted multi-directional mineral flow to converge and lead out. The cross section of the spiral chute and the different slopes of the curves are very suitable for sorting fine particle materials. Spiral chute slurry distribution 5. Applicable field: Fiberglass reinforced plastic chutes are suitable for processing 0.6-0.03mm and vein ores as well as sand ores, but high mud content is unfavorable for sorting. Nowadays, it has been widely used in the processing of iron ore, tungsten, tin, tantalum niobium ore, coastal and riverside ore sands, gold mines, and so on. Spiral chute slurry distribution