Can spiral chutes separate fine slurry? 1. Introduction: Gravity beneficiation is widely used in the beneficiation of metallic and non-metallic ores due to its low pollution and low cost. Fiberglass reinforced plastic chute is one of the gravity separation equipment, with a structural feature that the cross-section presents a cubic parabolic state, suitable for processing finer particle sizes of -0.2MM. During the selection process, do not add water for flushing, and divide the chute into sections at the end to select fine, medium, and tailings. 2、 The production principle is that the slurry is evenly distributed and slowly fed onto the surface of the spiral groove through the feeding chute installed on the rotating groove head, implementing sorting. The bottom of the rotating groove is equipped with a valve block type product selection groove, which divides the selection equipment into three types according to grade along the radial direction. By adjusting the position of the valve block to change the cutting width of each product, the equipment gathering hopper allows for the differentiation and aggregation of the obtained variable mineral flow. The cross-section of the spiral chute and the slope change of the curve are very suitable for the selection of fine particle materials. The spiral chute can separate fine slurry? III. Characteristics This machine is suitable for separating fine and small materials with Granularity of 0.3-0.02MM to obtain iron ore, ferrotitanium ore, chromite ore, pyrite, zircon sand, Rutile, monazite, phosphate rock, tungsten sand, sand tin, tantalite, tantalum niobium ore and other nonferrous metals, rare mineral metals and this nonferrous metal mineral body with gravity difference. This product also has the advantages of stable sorting process, simple control, wide range of allowable changes in ore concentration, high enrichment ratio, high recycling rate, small land area, small water consumption, simple structure, no power, large production capacity, easy installation, simple operation, small investment, and quick effectiveness. Can the spiral chute be divided into fine powder slurry? 4. The structure of the fiberglass spiral chute consists of a feeding average device, a cross (tripod), a feeding groove, a rotating groove, a selection groove, a gathering bucket, and a groove support. Can the spiral chute separate fine slurry? 5. Use This product is suitable for separating iron, ferrotitanium, chromite ore, pyrite ore, zircon ore, Rutile ore, monazite ore, phosphorus, tungsten, tin placer, tantalum niobium ore, niobium from fine materials with a particle size of 0.3-0.02mm, and has a specific gravity difference from other non-ferrous metal ores, rare ore metals or non-metallic minerals. Can the spiral chute separate fine powder slurry