news

Introduction to fiberglass spiral chute 1. The chute selection includes the inclined flow sorting process. Mineral mortar is fed to a partially inclined chute or inclined surface. Under the driving force of water flow, the mineral particle group is loose and layered, and the lighter minerals in the upper layer quickly flow out of the groove. The heavier minerals in the lower part either stagnate inside the groove or are discharged from the lower part at a low speed. After obtaining the difference, concentrate and tailings are obtained. The fiberglass spiral chute is a machine for mining and beneficiation, especially ideal for sand mining on coasts, riverbanks, sandbanks, and river beds. The equipment has the characteristics of correct structure, simple installation, small land occupation, simple operation, stable beneficiation, clear screening of minerals, large processing capacity, high efficiency, high beneficiation concentration ratio, high recovery probability, and stable operation. There are also advantages such as lightweight, moisture prevention, rust prevention, corrosion resistance, and strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 Operating principle: The spiral chute concentrator does not need to be restricted from being placed on the cross (or tripod) on the support table. The same mineral mortar is slowly fed onto the surface of the rotating groove through the feeding chute at the end of the installation spiral groove head, and selected for operation. The bottom is equipped with a valve block type equipment to obtain slots, allowing the sorted products to be divided into three (or four) types according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that collects and leads the intercepted multi head ore flow separately. The cross-section of the fiberglass chute and the change in slope of the curve are very suitable for the sorting of fine-grained materials. Fiberglass spiral chute III. Advantages: 1. Stable, easy to operate, and with a large density range. 2. Large material processing output, high enrichment ratio, and high recycling probability. 3. Small footprint, low water consumption, simple construction, and no need for power. 4. Easy installation, easy operation, minimal investment, and fast returns. fiberglass spiral chute 4. Structural composition: The spiral chute is composed of six parts: a feeding homogenizer, a feeding chute, a rotating chute, a product acquisition chute, an equipment gathering hopper, and a support bracket (including a cross or triangular frame). The spiral groove connected by the rotating disc is a key component. The spiral plate is made of fiberglass (fiber reinforced coal gangue), and a wear-resistant layer is pre made on the sorting surface of the rotating groove through bolts. She has the advantages of lightweight, strong, and durable consumer goods. Above the spiral groove, a multi tube feeding homogenizer is installed to evenly distribute the ore, and the operation is not complicated. The screening machine is not limited to being placed on the cross (or tripod) of the support table. The evenly distributed slurry is slowly fed onto the spiral groove surface through the feeding chute installed at the head of the rotating groove, and sorting is carried out. The tail end of the rotating groove is equipped with a valve block type new equipment to intercept the groove, allowing the sorted new products to be divided into three categories (or four categories) according to grade along the radial direction. Change the selection width of each new equipment by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that gathers and exports various obtained mineral flows. The lateral plane of the spiral concentrator and the slope change of the curve are extremely suitable for the selection of fine-grained materials. Fiberglass spiral chute 5. The use of a field spiral concentrator is suitable for processing 0.6-0.03 millimeters or vein ore and this mineral sand, but it is unfavorable for separation when the mud content is high. Currently, it has been widely used in the processing of iron, tungsten, sand tin, tantalum niobium, coastal or riverside sand mines, as well as sand gold mines. fiberglass spiral chute