What materials are used for spiral chutes? 1. Description: Gravity beneficiation is widely used in the beneficiation of metallic and non-metallic ores due to its low pollution and cost. The spiral concentrator is one of the gravity separation machines, with a structural feature that the cross-section presents a cubic parabolic shape, suitable for processing finer particle sizes of -0.2mm. In the sorting process, there is no need to add flushing water, and the fine, medium, and tailings are segmented at the tail end of the tank. 2、 Set up the spiral concentrator by using the method, calibrate the vertical line, fix the iron frame or wood at a suitable position, send the sand ore to the two ore inlets on the spiral top by the sand pump, add water, and adjust the concentration of the mineral slurry. The mineral slurry naturally swirls from high to low, generating a coherent centrifugal force in the flow rate of the whirling inclined surface, and obtaining the difference in the density, specific gravity, Granularity and shape of the mineral sand, Through the influence of the gravity of the swirling flow and the centrifugal force, the ore and sand are separated. The selected ore flows into the concentrate hopper and is piped out, while the tailings flow into the tailings hopper and are moved to the sand pit through a pipeline. Then, they are discharged by a sand pump, completing the entire beneficiation process. What materials are used for spiral chutes. 2. High material production yield, ultra-high enrichment ratio, and high recovery rate. 3. Small usage space, low water consumption, simple structure, and no need for power. 4. Easy installation, easy operation, low investment, and fast profitability. What materials are used for the spiral chute? 4. The structure of the spiral chute is composed of six parts: a feeding homogenizer, a feeding chute, a rotating groove, a product cutting groove, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The spiral groove connected by the rotating plate is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together through screws. The sorting surface of the rotating groove has one layer of pre designed durable wear-resistant layer. It has the advantages of lightweight, sturdy, and durable consumer goods. The spiral groove is equipped with a multi tube feeding homogenizer to screen minerals evenly, which is not cumbersome to operate. The mineral sorting equipment is freely stacked on the cross (or tripod) of the support table. The evenly distributed mortar is slowly fed to the spiral groove surface through the feeding groove installed at the head of the rotating groove, and the selection is carried out. The bottom of the rotating groove is installed in a valve block type new equipment to obtain the groove, allowing the sorted new products to be divided into three (or four) new products according to grade along the radial direction. Change the selection width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that distinguishes and converges the intercepted multi head ore flow. The cross-section of the fiberglass chute and the change in slope of the curve are particularly applicable for the selection of fine-grained materials. What kind of material is used for spiral chute? 5. Use This equipment is suitable for separating fine and small materials with Granularity of 0.3-0.02MM to obtain iron ore, Ilmenite, Chromite, pyrite, zircon sand, Rutile, monazite, phosphorus ethylene, tungsten ore, tin ore, tantalum, tantalum niobium ore, and other non-ferrous metals, rare mineral metals or nonferrous metal mineral bodies with different specific gravity. What material is used for the spiral chute