news

Rotating Spiral Chute Production Plant 1. Equipment Introduction: A gravity beneficiation equipment that utilizes the continuous centrifugal force generated by mineral mortar in spiral motion to achieve lightweight and heavy mineral separation. 2、 The glass fiber reinforced plastic spiral chute shall be set up with skills, aligned with the vertical line, and fixed in a suitable position with iron shelves or wood. The sand pump shall be used to transport the mineral sand to the two ore feeding ports above the spiral, add make-up water, and adjust the concentration of the mineral slurry. The mineral slurry naturally swirls from high to low. A single coherent centrifugal force appears in the rotating slope flow rate, and the difference in the gravity, Granularity and shape of the mineral sand is obtained, By utilizing the gravity and centrifugal force of the swirling flow, the sand and ore are separated, and the selected ore is discharged into the concentrate hopper and connected out through pipelines. The tailings enter the tailings hopper and are connected to the sand tank through pipelines, and then discharged by a mortar pump, completing the entire process of beneficiation. Rotary spiral chute production plant III. Advantages and characteristics: 1. High efficiency, high recovery rate, and correct mineral sorting; 2. No power required; 3. Small weight, anti rust, durable, anti wear, and strong corrosion resistance; 4. Low operating cost and long service life; 5. Strong adaptability to fluctuation of feed volume, density, Granularity and grade; The frictional force formed on the surface of 6 diamond sand makes the beneficiation efficiency better than other plastic surfaces. Rotating Spiral Chute Production Plant 4. Structural Composition: The fiberglass chute is composed of six parts: a feeding homogenizer, a feeding trough, a rotating trough, an equipment selection trough, a product gathering hopper, or a trough bracket (including a cross or triangular frame). The spiral groove formed by connecting spiral pieces is a key accessory. The rotating plate is made of fiberglass (fiberglass reinforced coal gangue), connected together by screws, and the rotating groove has a pre designed durable wear-resistant layer on the selected surface. It also has the advantages of light weight, durability, and durability in using consumer goods. Above the spiral groove is a multi tube feeding homogenizer that screens ore evenly, making it easy and convenient to operate. The sorting machine is not limited to being placed on the cross (or tripod) of the support table. The uniform mortar is slowly fed onto the spiral groove surface by installing the feeding groove at the head end of the rotating groove for sorting. The tail of the rotating groove is equipped with a valve type new equipment to cut the groove and classify the selected new products into three categories (or four categories) radially according to grade. Change the width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that allows the selected multi head ore flows to converge and lead out separately. The cross section and slope of the curve of the spiral concentrator are particularly suitable for the selection of fine-grained ore. The spiral chute can be used to separate fine grained iron, ferrotitanium, ferrochrome, ferrosulfide, tin ore, tantalum niobium, gold ore, coal, monazite, Rutile, zircon, rare earth and other metals and nonferrous gold ores with completely different specific gravity. Rotating Spiral Chute Production Plant