Introduction to the manufacturer of inner spiral chutes. The selection of chutes includes the inclined flow sorting process. Mineral mortar is fed to a partially inclined chute or inclined surface. Under the driving force of water flow, the mineral particle group is loose and layered, and the lighter minerals in the upper layer quickly flow out of the groove. The heavier minerals in the lower part either stagnate inside the groove or are discharged from the lower part at a low speed. After obtaining the difference, concentrate and tailings are obtained. The fiberglass spiral chute is a machine for mining and beneficiation, especially ideal for sand mining on coasts, riverbanks, sandbanks, and river beds. The equipment has the characteristics of correct structure, simple installation, small land occupation, simple operation, stable beneficiation, clear screening of minerals, large processing capacity, high efficiency, high beneficiation concentration ratio, high recovery probability, and stable operation. There are also advantages such as lightweight, moisture prevention, rust prevention, corrosion resistance, and strong applicability to fluctuations in ore feed volume, concentration, particle size, and grade. 2、 The technical principle is the same: the mortar is slowly fed to the rotating groove surface through a feeding groove installed on the spiral groove head for sorting. The tail end of the spiral groove is equipped with a valve block type product cutting groove, which divides the selected equipment into three types according to grade along the radial direction. By adjusting the orientation of the valve block to change the acquisition width of each product, the equipment gathering hopper allows the selected multi head ore flow to be differentiated and aggregated for export. The cross section of the spiral concentrator has different slopes, which is particularly suitable for the separation of small particle ore materials. Internal spiral chute manufacturer III. Advantages and characteristics: 1. High efficiency, high recovery rate, and correct mineral sorting; 2. No power required; 3. Small weight, rust proof, wear-resistant, and not easily corroded; 4. Low operating cost and long service life; 5. It is applicable to the fluctuation of feed volume, density, Granularity and grade; The friction formed by the surface of 6 diamond sand makes the beneficiation efficiency better than that of other plastic surfaces. internal spiral chute manufacturer IV. According to the size of ore processed, the chute can be divided into three categories: (1) coarse spiral chute. The maximum Granularity of ore feeding is more than 2-3MM, and the maximum can reach 100-200mm. (2) The sand ore chute is used to handle 2-3mm sized ore materials. (3) Slurry chute, feeding particle size less than 0.074 millimeters. Manufacturer V of the inner spiral chute applies this machine to separate 0.3-0.02mm fine materials to obtain iron, ferrotitanium, ferrochrome, ferrosulfur, zircon ore, Rutile ore, monazite ore, phosphorus, wolframite, tin ore, tantalum niobium, niobium ore and other non-ferrous metal ores, rare mineral metals and non-metallic minerals with gravity differences. Manufacturer of internal spiral chute at