news

Spiral Chute Plant 1. Overview: Gravity separation is widely used in the beneficiation of metal and non-ferrous metals due to its low pollution and low cost. Spiral chute is one of the gravity beneficiation machines, characterized by a cubic parabolic cross-section, suitable for processing finer particle sizes of -0.2 millimeters. During the sorting process, there is no need to add water for flushing, and the end of the chute is divided into sections to select fine, medium, and tailings. 2、 The glass fiber reinforced plastic spiral chute shall be set up with skills, aligned with the vertical line, and fixed in a suitable position with iron shelves or wood. The sand pump shall be used to transport the mineral sand to the two ore feeding ports above the spiral, add make-up water, and adjust the concentration of the mineral slurry. The mineral slurry naturally swirls from high to low. A single coherent centrifugal force appears in the rotating slope flow rate, and the difference in the gravity, Granularity and shape of the mineral sand is obtained, By utilizing the gravity and centrifugal force of the swirling flow, the sand and ore are separated, and the selected ore is discharged into the concentrate hopper and connected out through pipelines. The tailings enter the tailings hopper and are connected to the sand tank through pipelines, and then discharged by a mortar pump, completing the entire process of beneficiation. Spiral chute factory III. Highlights and characteristics: 1. Stable, easy to control, with a relatively large concentration range. 2. The material production and processing capacity is large, with a high enrichment ratio and a high probability of recovery. 3. The area is not occupied much, consumes less water, has a simple structure, and does not require power. 4. Easy installation, simple operation, low investment, and quick returns. Spiral Chute Factory 4. Structural Composition: The spiral concentrator is composed of six parts: a feeding homogenizer, a feeding trough, a spiral trough, an equipment selection trough, a product gathering hopper, and a trough bracket (including a cross or triangular frame). The spiral groove formed by connecting rotating discs is a key component. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together through screws. The sorting surface of the rotating groove has a pre designed durable wear-resistant layer. It has the advantages of lightweight, sturdy, durable, and durable consumer goods that are not easily damaged. A multi tube feeding homogenizer is installed above the rotating groove to sort minerals equally, making it easy to control. The concentrator does not need to be restricted from being placed on the cross (or tripod) of the support table. The evenly distributed slurry passes through the feeding chute installed at the head end of the spiral groove and slowly feeds onto the rotating groove surface for sorting. The tail of the spiral groove is equipped with a valve type new product acquisition groove, which allows the sorting equipment to be divided into three types (or four types) of new products along the radial direction according to grade. To adjust the orientation of the valve block and change the width of each new product, it is necessary to cut it off. The new equipment gathering bucket is a concentric annular tube that differentially collects and leads selected multi-directional mineral flows. The transverse surface of the fiberglass chute and the slope of the curve change greatly to adapt to the selection of fine-grained materials. Spiral chute plant 5. Applicable scope of this product is to separate iron, ferrotitanium, ferrochrome, ferrosulfide, zircon, Rutile, monazite, phosphate rock, wolframite, cassiterite, tantalum ore, niobium ore and other non-ferrous metal ores, rare ore metals and non-metallic minerals with specific gravity difference. Spiral Chute Factory